The Murphy Builders Site

Mike:

I don't recall riveting the inside corner wraps at the radias. I just
riveted on the wide flanges of the channels. I don't think you would
have enough edge material to rivet the inside narrower channels.

Thank you,

Del Schmucker
Information Systems Manager
Keewatin-Patricia District School Board
807-223-1254
807-221-8769 Cell
807-223-4703 Fax
del.schmucker@kpdsb.on.ca
www.kpdsb.on.ca

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Mike Betti
Sent: Tuesday, June 28, 2005 6:45 PM
To: rebel-builders@dcsol.com
Subject: Inside tail cone skin

Hi all,
I'm getting ready to install the floor channels prior to the floor skin.

I haven't riveted the lower outside corners in yet and was going to
rivet them once the floor channels are in place. Would I want to leave
the outside corners off to aid in drilling the inside lower corners from

the bottom up? A couple problems come to mind like maybe loosing
alignment of bulkheads by doing this and then the outer corners not
fitting again. Just looking for some ideas, with those small inside
radias to try and hit with a drill bit.
Thanks,
Mike Betti
771E



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------