The Murphy Builders Site

thanks for the replies on the 3/32" rivets.

One more quick question....

What type of quick connectors is used on the elevator trim and rudder trim
servo wires (to make installation and disassembly easier). And what type of
connectors are used to join the wires together from the supplied 30' spool to
the 5" short pieces on the servo.
Thanks.
Bob Scheuber
moose 191



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

I went thru hoops finding a nice connector when I did mine, BUT you know the
most dependable way is solder and shrink tube over top. If you have to
dissassemble... one snip and it's apart. Re-assembly took me all of 7
minutes today on CYP.

Wayne

----- Original Message -----
From: <bscheube@dcsol.com>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, May 31, 2005 3:06 PM
Subject: QUICK CONNECT

thanks for the replies on the 3/32" rivets.

One more quick question....

What type of quick connectors is used on the elevator trim and rudder trim
servo wires (to make installation and disassembly easier). And what type

of

connectors are used to join the wires together from the supplied 30' spool

to

the 5" short pieces on the servo.
Thanks.
Bob Scheuber
moose 191



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------