Page 1 of 1
New deburring method
Posted: Sat Feb 18, 2012 10:20 am
by Joel Jacobs
According to this site:
http://www.surftran.com/tem.html
I can deburr all my floor channels in less than 30sec by filling my garage
with natural gas and oxygen and lite'n it!
Joel
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
New deburring method
Posted: Sat Feb 18, 2012 10:20 am
by Wayne G. O'Shea
So just build the whole airplane and then use this method and you're done
and ready for paint! :LOL
----- Original Message -----
From: "Joel Jacobs" <
jj@sdf.lonestar.org>
To: "Rebel Builders" <
rebel-builders@dcsol.com>
Sent: Tuesday, March 29, 2005 3:29 PM
Subject: New deburring method
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
New deburring method
Posted: Sat Feb 18, 2012 10:20 am
by Mike Betti
I wish somebody would of told me about this before I got started!
----- Original Message -----
From: "Joel Jacobs" <
jj@sdf.lonestar.org>
To: "Rebel Builders" <
rebel-builders@dcsol.com>
Sent: Tuesday, March 29, 2005 2:29 PM
Subject: New deburring method
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
New deburring method
Posted: Sat Feb 18, 2012 10:20 am
by Ken
Stay in the garage to strike the match and you can get a shave and a
haircut at the same time :)
Ken
Joel Jacobs wrote:
According to this site:
http://www.surftran.com/tem.html
I can deburr all my floor channels in less than 30sec by filling my garage
with natural gas and oxygen and lite'n it!
Joel
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
New deburring method
Posted: Sat Feb 18, 2012 10:20 am
by Drew Dalgleish
Yeah if you stack the parts just right you can explosively weld them at the
same time and not need to rivet at all. See
http://www.britannica.com/eb/article?tocId=7858
That must be why Daryl chose 6061 T6 weldable alloy :)
At 06:39 PM 3/29/2005 -0500, you wrote:
Drew
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------