Rebel - Fus 25
Posted: Sat Feb 18, 2012 10:16 am
Just a "hint post" that I remembered while doing this section of a rebuild
over the last week. Before riveting that Fus-25 down (that I would remake
out of .032 or .025) remember to mark a continuation of the crease line from
the tailcone panel onto the Fus-25. All you need to do is close the brake on
the sheet to make enough of a crease. This will get rid of the stupid look
of one smooth panel on the side. Tailcone is creased and so is the door
skin. Having the Fus-25 in between smooth just looks stupid.
Wayne
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
over the last week. Before riveting that Fus-25 down (that I would remake
out of .032 or .025) remember to mark a continuation of the crease line from
the tailcone panel onto the Fus-25. All you need to do is close the brake on
the sheet to make enough of a crease. This will get rid of the stupid look
of one smooth panel on the side. Tailcone is creased and so is the door
skin. Having the Fus-25 in between smooth just looks stupid.
Wayne
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------