spring gear:
Posted: Fri Feb 17, 2012 5:26 pm
Hi!
I'm making the top gusset plate (SG-8) and sculpted plate (SG-14). In
fig. 8 I'm told to make 2" x 1.25" tabs on SG-14 that stick out past the
floor. Then in fig 9 I'm supposed to make the top gusset plate with
similar dimensions, but the tabs are now 1.75" x 1.25". So which is it,
1.75 or 2.00? If it really is 1.75, what edges line up on the two parts?
Are there any other 'typos' anytime soon in this section of the manual?
Thanks,
Dan
PS: Thanks, Alister, for the response to the bolt question.
I'm making the top gusset plate (SG-8) and sculpted plate (SG-14). In
fig. 8 I'm told to make 2" x 1.25" tabs on SG-14 that stick out past the
floor. Then in fig 9 I'm supposed to make the top gusset plate with
similar dimensions, but the tabs are now 1.75" x 1.25". So which is it,
1.75 or 2.00? If it really is 1.75, what edges line up on the two parts?
Are there any other 'typos' anytime soon in this section of the manual?
Thanks,
Dan
PS: Thanks, Alister, for the response to the bolt question.