The Murphy Builders Site

In a message dated 2/9/04 12:27:21 PM Central Standard Time,
oxyport@globetrotter.net writes:

To contersink the end rib, I use the little Mam tool that woork fine
except.....at the end of the rib! There is not suffisant space between to run the
"nail".. How should I do it?

JEAN
I bought an extra set of dimpling disc that you pull with a 6 penny nail,
like the ones supplied. And ground a flat spot on one side for those tight spots.
As long as you don't grind past the dimpling area you're good to go.
Phil&Lisa Smith
#460R
N414D



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://www.dcsol.com/default.htm
Archives public username "rebel" password "builder"
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------