The Murphy Builders Site

Has anyone thought about or asked MAM about creating fiberglass tips for the elevator. It would play into the balancing. Fabrication wouldn't be hard, but if you did this what would the impact be? I just wondered if people had asked, the rather square ends are not the most attractive.

Rick Muller
SR70

-----Original Message-----
From: Steve Halvorsen <shalvorsen@dataflo.net>
Sent: Jan 26, 2004 5:55 PM
To: murphy-rebel@dcsol.com
Subject: Balancing of Controls


While everyone is on this subject----- What is the correct way to balance
them? ? ?
I always thought that you would balance them on the pivot line to a neutral
balance.
I asked Brian at MAM about the weights that were supplied with our kit and
his answer was to just put the weights that were sent in and fly. That's
what everyone else does.
Is this correct? ? ? ? ?

Steve H
Moose 213




*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*






*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------