The Murphy Builders Site

Hello every body!

Couple of weeks ago, I asked for the degree of the blind flush rivet and if it exist a tool to make the "cut". The use of a 1/2" drill bit is not very pricise.....

I think I have found what evry one is looking for!!!!

For solid rivet I use a "Micro-Stop Contersink" ( unfortunatly, it is 100 degree), but.... I found the cutter that fit that tool with the 120 degree included angle". The "Micro-Stop Contersink" I use have buy from Leavens couple years ago.

"Newman Tools Inc." send me a complete list of that type of little cutter. they are made off high speed steel and they call them
"Chatter free stop contersink cutters"

The cutters on my micro-stop have a body of 1/2" diam., thread of 1/4"-28 , 1-5/32" length.

for #40 part number is SEV.SC-8-60-40P
for #30 part number is SEV.SC-8-60-30P
for 3/16" (they show 3/16 or #10 but not #11) part number is SEV-8-60-316

They are between $35.00 and $45.00 ea.

They also have a lot of different deburring tools. One is call "Double Burr" and it deburre both side of thin material at the same time!

The company have moved. There new address after jan 1, 2004 Newman Tools inc.
185 Iber Road
Ottawa, Ontario
K2S 1E7
phone: 800-465-1384
fax: 800-605-2442

ask for Tom or Nancy.

I hope this can be helpful

Jean
Rebel 747R





*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------