The Murphy Builders Site

Wing spar observation -

Got the right wing spar all drilled to 40 and all of the left side except for
the tip extensions. I looked at the Fig 14 and noticed that the end view shows
the tip extenders nested outside the main spar. Good time to stop for the
night since I put the right side tip extentions on the inside of the main
spar. A call to tech support and Brian said that he puts them on the inside
so I am all set. I was woried it would change a rib dimension down the road
but I guess not. You gotta love it when you make a mistake and it turns out
ok!!

Also - I groveled with the lightening hole cutouts trying to use the suggested
fly cutter - tried a milling bit (lasted 5 minuits for $5 and a pain to drive)
for the drill, burned out my dremel tool and was eating up lots of time when I
got a pack of 34 tooth metal blades for my jig saw - I have never had so much
fun with that thing - Did the whole left spar and it hasn't even started to
wear.

Britt - SR194


*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------