The Murphy Builders Site

MAM has responded to me that the standard Elite taildragger forward
upper corner wraps are FUS-10 at .010 and the lower forward corner wraps
are FUS-70 at .025.
Ralph Baker
Elite 624E


*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Your typo or their's Ralph?? Fus-10's are .020"

Wayne

----- Original Message -----
From: "Ralph Baker" <rebaker@ftc-i.net>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 25, 2003 9:39 AM
Subject: Elite taildragger forward corner wraps

MAM has responded to me that the standard Elite taildragger forward
upper corner wraps are FUS-10 at .010 and the lower forward corner wraps
are FUS-70 at .025.
Ralph Baker
Elite 624E

*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

MEA CULPA
Fortunately, I drill better than type.
The FUS-10 is .020, not .010 as stated in error below.
Ralph



----- Original Message -----
From: "Ralph Baker" <rebaker@ftc-i.net>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 25, 2003 9:39 AM
Subject: Elite taildragger forward corner wraps

MAM has responded to me that the standard Elite taildragger forward
upper corner wraps are FUS-10 at .010 and the lower forward corner wraps
are FUS-70 at .025.
Ralph Baker
Elite 624E

*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------