The Murphy Builders Site

Steve, if you haven't painted yet and have the heavier wraps in all the
other corners then why not do the upper tailcone/cabin transitions with
FUS-70's before you paint. As I said in the original post I see a lot of
these getting buckled from hard tailwheel or three point landings, as they
compress. Haven't had any problems with my personal ones and they have been
.025 FUS-70's from the get go.

Cheers,
Wayne

----- Original Message -----
From: "steve whitenect" <srwhitenect@hotmail.com>
To: <murphy-rebel@dcsol.com>
Sent: Thursday, November 20, 2003 4:04 PM
Subject: Re: Barnstormers

Thanks Wayne Haven't been able to bring it up under the old address

listed

on my favourites after being in the woods for 2 months. Now have lots to
catch up on. Oh, I had a question for u. I see some talk on the corner
wraps. I believe the "wrap of the day" is for fus 70 on the rear upper
corners. First I have heard of this. I used the .032 in all four lower
corners with all know float mods. fus 70 in the front uppers and fus 10

in

the upper rears. Now apparently this is not sufficient. What is ur

opinion

on what I have assembled in regards to not having the 70's at the rear

upper

position. Haven't painted yet and could replace them. Thanks in advance,

Steve W.

*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------