The Murphy Builders Site

Actually should have said right behind the butterfly doubler on the top
section. Have sent Ken a picture! IF anyone else wants "proof" let me know
and I'll send direct to you.
Wayne

----- Original Message -----
From: "Wayne G. O'Shea" <oifa@irishfield.on.ca>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 18, 2003 10:55 PM
Subject: Re: Elite Oil Canning Corner Wraps Etc., was: Re: Elite cage rivets
left out

In the middle of the top area. Will see if I can find a picture! Pretty

sure

I have one from Charles D's Mississippi Rebel.
Wayne

----- Original Message -----
From: <klehman@albedo.net>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 18, 2003 10:29 PM
Subject: Re: Elite Oil Canning Corner Wraps Etc., was: Re: Elite cage

rivets

left out

Hi Wayne

For the top tail cone corner wraps, can you tell if the buckle starts
along the top rivet line or does the whole thing just start to crumple
in the middle?

thanks
Ken

Wayne G. O'Shea wrote:

Know's the time to replace those top two corner wraps Al, before

paint,

as

they will start to buldge after a couple rough strips and will buckle

after

a good hard landing.

Then again if you are sticking with the tricycle gear configuration

they

won't be an issue, as the load will try to stretch them in a hard

landing

instead of compressing them in the case of a tailwheel configured

aircraft!

Wayne

*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*
*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------