The Murphy Builders Site

In the middle of the top area. Will see if I can find a picture! Pretty sure
I have one from Charles D's Mississippi Rebel.
Wayne

----- Original Message -----
From: <klehman@albedo.net>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 18, 2003 10:29 PM
Subject: Re: Elite Oil Canning Corner Wraps Etc., was: Re: Elite cage rivets
left out

Hi Wayne

For the top tail cone corner wraps, can you tell if the buckle starts
along the top rivet line or does the whole thing just start to crumple
in the middle?

thanks
Ken

Wayne G. O'Shea wrote:

Know's the time to replace those top two corner wraps Al, before paint,

as

they will start to buldge after a couple rough strips and will buckle

after

a good hard landing.

Then again if you are sticking with the tricycle gear configuration they
won't be an issue, as the load will try to stretch them in a hard

landing

instead of compressing them in the case of a tailwheel configured

aircraft!

Wayne

*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------