I have one from Charles D's Mississippi Rebel.
Wayne
----- Original Message -----
From: <klehman@albedo.net>
To: <murphy-rebel@dcsol.com>
Sent: Tuesday, November 18, 2003 10:29 PM
Subject: Re: Elite Oil Canning Corner Wraps Etc., was: Re: Elite cage rivets
left out
asHi Wayne
For the top tail cone corner wraps, can you tell if the buckle starts
along the top rivet line or does the whole thing just start to crumple
in the middle?
thanks
Ken
Wayne G. O'Shea wrote:Know's the time to replace those top two corner wraps Al, before paint,
afterthey will start to buldge after a couple rough strips and will buckle
landinga good hard landing.
Then again if you are sticking with the tricycle gear configuration they
won't be an issue, as the load will try to stretch them in a hard
aircraft!instead of compressing them in the case of a tailwheel configured
*-------------------------------------------------------------------------*Wayne
*-------------------------------------------------------------------------*To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------