Page 1 of 1

Amphibiouir float

Posted: Fri Feb 17, 2012 11:54 pm
by Dale Kopff
Since type A transmission fluid is no longer available, what is the
recomended replacement tramsmission fluid used for the amphibious pump?

Dale
N295RT






*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Amphibiouir float

Posted: Fri Feb 17, 2012 11:54 pm
by Wayne G. O'Shea
Dale, I use Dextron III in everything. Float hydraulics and MAM brake
systems. 10 years and the stuff has never ate an O-ring!!

Wayne

----- Original Message -----
From: "Dale Kopff" <dkopff@earthlink.net>
To: <murphy-rebel@dcsol.com>
Sent: Friday, October 03, 2003 5:37 PM
Subject: Amphibiouir float

Since type A transmission fluid is no longer available, what is the
recomended replacement tramsmission fluid used for the amphibious pump?

Dale
N295RT






*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Amphibiouir float

Posted: Fri Feb 17, 2012 11:54 pm
by Legeorgen
Wayne,

Any suggestions on what to use for a hydraulic tank on the Amphibs? MAM has
yet to locate a source for one and I don't think it's on their priority list so
I'm not holding my breath in hopes I'll receive one soon.

Bruce 357R



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Amphibiouir float

Posted: Fri Feb 17, 2012 11:54 pm
by Wayne G. O'Shea
Something as simple as a quart can from Acetone. Proseal a couple of fuel
tank fittings on the wide side for a couple compression fittings and a clear
tube for sight gauge. Another couple fittings for the inlet and outlet and
don't forget a small vent hole in the original lid.

That's probably 4 tank fittings you don't have though and something you
shouldn't have to do after forking out the $$'s. Get any of your other back
orders yet?

----- Original Message -----
From: <Legeorgen@aol.com>
To: <murphy-rebel@dcsol.com>
Sent: Friday, October 03, 2003 7:29 PM
Subject: Re: Amphibiouir float

Wayne,

Any suggestions on what to use for a hydraulic tank on the Amphibs? MAM
has
yet to locate a source for one and I don't think it's on their priority
list so
I'm not holding my breath in hopes I'll receive one soon.

Bruce 357R



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Amphibiouir float

Posted: Fri Feb 17, 2012 11:54 pm
by Legeorgen
I have received most of the back orders for my floats, last I checked. I
called them often and was a squeaky wheel. Other than a few clevis pins and
miscellaneous nuts and bolts hardware that where just missing on the packing list
(you knew about those because you brought them to my attention) which I just
picked up locally because it was more convenient.

I take it MAM have not sent you anything from your back order since May?
Wheels, tubes, tires, tanks, hydraulic switch control and the likes?

Bruce 357R



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------