venting 101

[Murray and Carol Cherkas]

OK pretty basic but think about it.
Came out of the wing with a 1/4 pipe thread to #6 flair, 3/8 tube into
fuselodge to Tee fitting. Same on both sides. Now you have to connect the
two tee's. Instead of going straight across I felt that there should be a
little room for shrinkage and expansion so I drilled the centre channel on
the roof 1 1/2" forward of the root rib holes and as high as possible all
though very little height can be gained I kept the high point in the
middle.This allows two bends at each end of the centre tube which I think
will give and take a little bit, maybe not much but something is better than
nothing.

Good luck to all

Murray

Almost flying. Going to the paint shop next week.



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
http://www.dcsol.com:81/public/code/html-subscribe.wcx
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------