The Murphy Builders Site

A quick eyeball (we are not rigged yet) has me wondering if I will need
to shorten the sticks so they will go under the lower panel edge in
order to get enough throw for +/- 25 degrees at the elevator. The lever
arm at the control column is 1 3/4" and at the elevator 3 1/4" so the
stick will have to travel many more degrees. And, this is without
considering the geometry change during the stick throw. Has this been a
problem for anyone else?
Thanks,
Ralph Baker
Elite 624E


*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
http://www.dcsol.com:81/public/code/html-subscribe.wcx
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Ralph, I generally end up cutting a small amont off the sticks to clear the
switches on the left instrument panel face, but not the middle section. You
don't need 25* nose down elevator for anything, so just set you stops as
required so the sticks don't bang the panel. 10 or 15* nose down is more
than you will ever need for anything. I use full forward stick to briefly
lift the tailwheel out of the snow to taxi, but for nothing else. Even
negative G "rollercoaster" rides for the kids only require about 3 inches of
quick forward stick motion!! ;o)

Cheers,
Wayne O'Shea
oifa@irishfield.on.ca
www.irishfield.on.ca


----- Original Message -----
From: "Ralph Baker" <rebaker@ftc-i.net>
To: <murphy-rebel@dcsol.com>
Sent: Sunday, May 04, 2003 10:11 PM
Subject: Stick travel on Elite

A quick eyeball (we are not rigged yet) has me wondering if I will need
to shorten the sticks so they will go under the lower panel edge in
order to get enough throw for +/- 25 degrees at the elevator. The lever
arm at the control column is 1 3/4" and at the elevator 3 1/4" so the
stick will have to travel many more degrees. And, this is without
considering the geometry change during the stick throw. Has this been a
problem for anyone else?
Thanks,
Ralph Baker
Elite 624E

*-------------------------------------------------------------------------*

To unsubscribe from this list go to:
http://www.dcsol.com:81/public/code/html-subscribe.wcx
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*




*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
http://www.dcsol.com:81/public/code/html-subscribe.wcx
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------