Rudder cables and springs

[Rickhm at home]

In checking the manual (our favorite subject) and my invoice it indicates
that I should use some springs as part of the rudder cable install. The
only springs that I think I have are those that are used to go from the
rudder to the tail wheel. I have 6 of these. Am I correct to assume that
2 go from rudder to tail wheel, 2 are up by the rudder peddles as outlined
in the manual and 2 are used somewhere else or are spares? The springs are
zinc plated and about 4" long. There is a picture on the web site of the
rudder/cable attachment. At the bottom of the picture you can see the
springs I am thinking of.

Thoughts?

Rick Muller
SR70


*** File "WINMAIL.DAT" has been uudecoded and attached to this message.


*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
http://www.dcsol.com:81/public/code/html-subscribe.wcx
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------