firewall
Posted: Fri Feb 17, 2012 4:52 pm
Received: from [206.40.137.200] by woodinville.netos.com
(Post.Office MTA v3.1.2 release (PO205-101c)
ID# 0-38159U2500L250S0) with ESMTP id AAA168
for <murphy-rebel@dcsol.com>; Wed, 6 Jan 1999 15:39:11 -0800
X-Mailer: Microsoft Outlook Express Macintosh Edition - 4.5 (0410)
Date: Wed, 06 Jan 1999 15:39:05 -0800
Subject: firewall
From: "Dan Morehouse" <dan.morehouse@netos.com>
To: "murphy-rebel @dcsol.com" <murphy-rebel @dcsol.com>
Mime-version: 1.0
X-Priority: 3
Content-type: text/plain; charset="US-ASCII"
Content-transfer-encoding: 7bit
Message-ID: <19990106233911129.AAA168@[206.40.137.200]>
Hello!
Just finished placing the witches hat sections on the front and back of the
firewall. If I were to do it over again, I'd consider putting on these
pieces before drilling for the top, bottom, and sides that attach to the
firewall. Putting the witches hat on could make for a straighter firewall to
drill into it's flanges.
Also, since I may put insulation and ss steel on the front of the firewall,
I'm waiting to drill out to #30 until that time.
Finally, MAM suggests a 2" channel to go between the top two motor mounts.
What is this made of?
Cheers,
Dan
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
(Post.Office MTA v3.1.2 release (PO205-101c)
ID# 0-38159U2500L250S0) with ESMTP id AAA168
for <murphy-rebel@dcsol.com>; Wed, 6 Jan 1999 15:39:11 -0800
X-Mailer: Microsoft Outlook Express Macintosh Edition - 4.5 (0410)
Date: Wed, 06 Jan 1999 15:39:05 -0800
Subject: firewall
From: "Dan Morehouse" <dan.morehouse@netos.com>
To: "murphy-rebel @dcsol.com" <murphy-rebel @dcsol.com>
Mime-version: 1.0
X-Priority: 3
Content-type: text/plain; charset="US-ASCII"
Content-transfer-encoding: 7bit
Message-ID: <19990106233911129.AAA168@[206.40.137.200]>
Hello!
Just finished placing the witches hat sections on the front and back of the
firewall. If I were to do it over again, I'd consider putting on these
pieces before drilling for the top, bottom, and sides that attach to the
firewall. Putting the witches hat on could make for a straighter firewall to
drill into it's flanges.
Also, since I may put insulation and ss steel on the front of the firewall,
I'm waiting to drill out to #30 until that time.
Finally, MAM suggests a 2" channel to go between the top two motor mounts.
What is this made of?
Cheers,
Dan
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------