Main Gear Drag Loads - What's Murphy doing about it?
Posted: Fri Feb 17, 2012 10:24 pm
Folks,
I have been following this post but have been busy so
maybe I missed it...
What's Murphy doing about it? Are they planning on
redesigning the gearbox area to solve this? Making it
beefier? Or just fixing it with braces, channels and
doublers!?
In my opinion, sounds like the gear fittings need to
be totally redesigned from scratch...similar to the
Ponk ones mentioned previously.
-Jason
=====
________________________________________________
Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com
__________________________________________________
Do you Yahoo!?
New DSL Internet Access from SBC & Yahoo!
http://sbc.yahoo.com
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I have been following this post but have been busy so
maybe I missed it...
What's Murphy doing about it? Are they planning on
redesigning the gearbox area to solve this? Making it
beefier? Or just fixing it with braces, channels and
doublers!?
In my opinion, sounds like the gear fittings need to
be totally redesigned from scratch...similar to the
Ponk ones mentioned previously.
-Jason
=====
________________________________________________
Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com
__________________________________________________
Do you Yahoo!?
New DSL Internet Access from SBC & Yahoo!
http://sbc.yahoo.com
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------