The Murphy Builders Site

Randy, Don, anybody,
Approximately how much of the brush able PS 890 is enough for fixing the quick build leaks? Pint kit or Qt?

Thanks,
Scott Aldrich
N174SL Moose #174

Scott
I coated all the interior joints and rivets on a 3 bay Rebel tank with a
3.5 oz. semkit of brushable.
Ken

S & L Aldrich wrote:

Randy, Don, anybody,
Approximately how much of the brush able PS 890 is enough for fixing
the quick build leaks? Pint kit or Qt?

Thanks,
Scott Aldrich
N174SL Moose #174

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

If you have quite a few leaks per tank as we did, you will need to brush all the seams, joints, rivets, stringers, etc of the tank interiors. If this is the case we used 3 pints total for the brushing process only. Thats after 2 pints of putty meticulously working possible leak by possible leak. Its not fun. ( Wish i was done ) I have my final pint to go out and finish the job. If you have a couple leaks, know where they are, i think you should brush one pint per tank as a final "seal all" coating for a perfect job. Good luck.
Randy Bowers SR130

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------