The Murphy Builders Site

My manual calls for RR-5606 stainless steel rivets to hold the aileron horn to the tube in the wing. My inventory shows no 5606. I do have a batch of 70 labeled and inventoried as RR-5604 but they only measure 1/8 in. dia.x 3/8 in. length. Shouldn't these be 3/16 dia x 1/4 and do I need 5606 for the aileron need?
My manual is written for the 2500. I have the 120 gal fuel option. Am I correct that my fuel bays run out to main rib #8?
Thank you, I am enjoying the build very much so far.
Jim Goodwin
goody@sover.net (goody@sover.net)
802.343.1775

Hi Jim
I think you might have meant to send this to the factory instead of this
independant builders list. In any event I can tell you that the standard
rebel does indeed require the longer 3/8" grip rivets there. Always a
good idea to measure the part thickness if in doubt. I'm sure MAM will
send the correct rivets if you contact them.
Ken

goody wrote:

My manual calls for RR-5606 stainless steel rivets to hold the aileron
horn to the tube in the wing. My inventory shows no 5606. I do have
a batch of 70 labeled and inventoried as RR-5604 but they only measure
1/8 in. dia.x 3/8 in. length. Shouldn't these be 3/16 dia x 1/4 and
do I need 5606 for the aileron need?
My manual is written for the 2500. I have the 120 gal fuel option.
Am I correct that my fuel bays run out to main rib #8?
Thank you, I am enjoying the build very much so far.
Jim Goodwin
goody@sover.net
802.343.1775

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------