The Murphy Builders Site

Rebelheads:

Just as soon as I sent my last post on this subject, I turned once again to
my binder and amazingly flipped to the very last pages of Chapter 12 and
found the illusive Float Attach Point Installation directions. See Chapter
12.27 (page101). Far cry from Chapter 15! Easter egg hunt is over.

However, if anyone has any comments concerning this subject . . . have at
it.

Your Pilot Pal,

Terry Dazey
Rebel 662

What do you call a cow with no legs? . . . .

Ground beef!




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Don't forget that "1/4 circle" x .063 doubler I recommended to put on the
forward bulkhead on each side of the float point bulkhead pair to stiffen
them up a bit. Or order 2 of the FUS-488 (I think that was the number!) .040
float point doublers for the ELITE from MAM.

Wayne

----- Original Message -----
From: "Terry Dazey" <dazey@earthlink.net>
To: <murphy-rebel@dcsol.com>
Sent: Saturday, January 19, 2002 11:37 PM
Subject: Rebel Float Attach Pionts . . . I found it!

Rebelheads:

Just as soon as I sent my last post on this subject, I turned once again

to

my binder and amazingly flipped to the very last pages of Chapter 12 and
found the illusive Float Attach Point Installation directions. See

Chapter

12.27 (page101). Far cry from Chapter 15! Easter egg hunt is over.

However, if anyone has any comments concerning this subject . . . have at
it.

Your Pilot Pal,

Terry Dazey
Rebel 662

What do you call a cow with no legs? . . . .

Ground beef!


** To unsubscribe, send e-mail to list-server@dcsol.com with

**

** UNSUBSCRIBE MURPHY-REBEL in the message body on a line by itself

**

** Archives located at http://rebel:builder@www.dcsol.com:81/default.htm

**

** To contact the list admin, e-mail mike.davis@dcsol.com

**




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

on 1/19/02 8:45 PM, Wayne G. O'Shea at oifa@irishfield.on.ca wrote:

Don't forget that "1/4 circle" x .063 doubler I recommended to put on the
forward bulkhead on each side of the float point bulkhead pair to stiffen
them up a bit. Or order 2 of the FUS-488 (I think that was the number!) .040
float point doublers for the ELITE from MAM.

Wayne

Yes, Wayne. I am ordering the Elite FUS-448's in lieu of the .063 doublers
from MAM next week along with the other O'shea mod materials.


Thanks!

Terry




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------