The Murphy Builders Site

I used a long drill bit mounted in the drill press. I clamped the tube to
the table and rotated it 90degrees. It was a slow process chipping out the
weld.

----- Original Message -----
From: <rmowat@dcsol.com>
To: <murphy-rebel@dcsol.com>
Sent: Wednesday, January 02, 2002 9:28 PM
Subject: SR3500 - Rudder Pedal Assembly

The rudder pedal assembly has welded fittings that seem to prevent slave

tube

from properly sliding into tube - How does one ream or clean out the welds

to

allow the tubes (RP18) to slide nicely in the CC102 Tubes?

** To unsubscribe, send e-mail to list-server@dcsol.com with

**

** UNSUBSCRIBE MURPHY-REBEL in the message body on a line by itself

**

** Archives located at http://rebel:builder@www.dcsol.com:81/default.htm

**

** To contact the list admin, e-mail mike.davis@dcsol.com

**




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------