The Murphy Builders Site

Resending this bc don't think the original went
through...

Hi all,

Need to trim the fiberglass fairing for the hor. stab.
for my SR. I have never worked with fiberglass before.
What's the best way to cut and trim fiberglass? I was
thinking of using a dremel tool with a cut off wheen
and then filing to the line. That ok? Do's and don'ts?

Thanks,

-jason

=====
________________________________________________

Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com

__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

In a message dated 8/2/01 3:43:29 PM Central Daylight Time,
super_rebel131@yahoo.com writes:

Need to trim the fiberglass fairing

JASON
If it's not to thick you can use you're aviation snips. For long cuts or
flatter surfaces use you're bull snips. Then sand to final with a palm
sander. ALWAYS wear a mask so you don't breath the dust, the rosin or the
glass for that matter doesn't do the body any good.
Phil&Lisa Smith #460R N414D

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

I used a Dremel with a cut-off wheel and it worked excellent for me. Very
quick and easy. Wear a mask though. Lot's of fiberglass dust in the air.

Mike Kimball
SR#044

-----Original Message-----
From: murphy-rebel@dcsol.com [mailto:murphy-rebel@dcsol.com]On Behalf Of
Jason Beall
Sent: Thursday, August 02, 2001 12:43 PM
To: murphy-rebel@dcsol.com
Subject: cutting and trimming fiberglass


*-------------------------------------------------------------------------*
The list archives are located at:
http://www.dcsol.com:81/public/default.htm
username: rebel password: builder
*-------------------------------------------------------------------------*
Resending this bc don't think the original went
through...

Hi all,

Need to trim the fiberglass fairing for the hor. stab.
for my SR. I have never worked with fiberglass before.
What's the best way to cut and trim fiberglass? I was
thinking of using a dremel tool with a cut off wheen
and then filing to the line. That ok? Do's and don'ts?

Thanks,

-jason

=====
________________________________________________

Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com

__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
*-------------------------------------------------------------------------*
You have received this message because you have subscribed to the
murphy-rebel mailing list.
To unsubscribe from this list, send an e-mail to: list-server@dcsol.com
with "unsubscribe murphy-rebel" in the body of the message.
For assistance contact mike.davis@dcsol.com
*-------------------------------------------------------------------------*





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------