Cutting thin aluminum sheet
Posted: Fri Feb 17, 2012 9:02 pm
Gwtting in to hard spots or cutting slots in thin sheet I found a Black and
Decker Wizard with disc cutter works very well and is very fast leaving a
nice edge with very little clean up. I would recommend a little practice on
scrap first to get the hang of it. Also recommend using goggles as WHEN the
little discs get caught as they sometimes do if one is not careful, they
shatter and throw a certain amount of shrapnel around.
Mike Le Ber R683
Decker Wizard with disc cutter works very well and is very fast leaving a
nice edge with very little clean up. I would recommend a little practice on
scrap first to get the hang of it. Also recommend using goggles as WHEN the
little discs get caught as they sometimes do if one is not careful, they
shatter and throw a certain amount of shrapnel around.
Mike Le Ber R683
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------