Page 1 of 1

Rebel Height - mounted per MAM on 1800's

Posted: Fri Feb 17, 2012 9:02 pm
by Wayne G. O'Shea
Steve, the Rebel when mounted per MAM's instructions, as to height, has an
under wing clearance of 7'6" at the aileron horn and 7'8" at the wing tip.
The one I have on 1500's is maybe an inch lower. The tail fin will go
through a 10 foot opening with a bit of clearance and is the highest point
UNLESS you have roof mounted antennas, and then these become the highest
point that should still squeeze through a 10 foot door.

Take care,
Wayne G. O'Shea
www.irishfield.on.ca

----- Original Message -----
From: <SWSLOANLK@aol.com>
To: <murphy-rebel@dcsol.com>
Sent: Sunday, June 17, 2001 11:34 AM
Subject: Re: Aviation Humor!


*-------------------------------------------------------------------------*
The list archives are located at:
http://www.dcsol.com:81/public/default.htm
username: rebel password: builder
*-------------------------------------------------------------------------*
Wayne

Thanks for the bits of Aviation Humor. On a side note, I knew Ernest Gann
personaly, and flew him on a number of occasions between his home on San
Juan
Island and Seattle Washington in my 182 Skylane.He was a person of many
interests, and quite a pilot.

Could you give me the distance from the underside of the rebel wing to the
ground on your float equip Rebel with the wheels down. I am getting close
to
mounting my 1800 ,s and need this distance to see if the wing will go over
a
small office/shop in my hangar.

Regards,
Steve Sloan 536R
*-------------------------------------------------------------------------*
You have received this message because you have subscribed to the
murphy-rebel mailing list.
To unsubscribe from this list, send an e-mail to: list-server@dcsol.com
with "unsubscribe murphy-rebel" in the body of the message.
For assistance contact mike.davis@dcsol.com
*-------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Rebel Height - mounted per MAM on 1800's

Posted: Fri Feb 17, 2012 9:02 pm
by SWSLOANLK
Thanks Wayne.

It will fit through the hangar door ok but not over the shop roof.

Best Regards,

Steve Sloan 536R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Rebel Height - mounted per MAM on 1800's

Posted: Fri Feb 17, 2012 9:02 pm
by Wayne G. O'Shea
Nothing a chain saw won't fix, is it???

----- Original Message -----
From: <SWSLOANLK@aol.com>
To: <murphy-rebel@dcsol.com>
Sent: Sunday, June 17, 2001 3:12 PM
Subject: Re: Rebel Height - mounted per MAM on 1800's


*-------------------------------------------------------------------------*
The list archives are located at:
http://www.dcsol.com:81/public/default.htm
username: rebel password: builder
*-------------------------------------------------------------------------*
Thanks Wayne.

It will fit through the hangar door ok but not over the shop roof.

Best Regards,

Steve Sloan 536R
*-------------------------------------------------------------------------*
You have received this message because you have subscribed to the
murphy-rebel mailing list.
To unsubscribe from this list, send an e-mail to: list-server@dcsol.com
with "unsubscribe murphy-rebel" in the body of the message.
For assistance contact mike.davis@dcsol.com
*-------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------