Moose stinger attach bolt wear
Posted: Sun Feb 19, 2012 11:37 pm
During my condition inspection, I removed the bolt holding my stinger
(LG0066) to the forward FUS-360 attach bracket. There was noticeable wear
on the bolt!
I posted a picture showing the shear-load wear to Area 115 -- S/M Landing
Gear. If anyone would like me to mail the picture to them directly just
drop me an email at tedwaltman@gmail.com.
I have 509 hours with approximately 440 landings on this bolt. It would
seem that replacing (or at least very carefully inspecting) this bolt at
every annual condition inspection might be warranted!!
Ted
Moose
Denver, Colorado
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
(LG0066) to the forward FUS-360 attach bracket. There was noticeable wear
on the bolt!
I posted a picture showing the shear-load wear to Area 115 -- S/M Landing
Gear. If anyone would like me to mail the picture to them directly just
drop me an email at tedwaltman@gmail.com.
I have 509 hours with approximately 440 landings on this bolt. It would
seem that replacing (or at least very carefully inspecting) this bolt at
every annual condition inspection might be warranted!!
Ted
Moose
Denver, Colorado
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------