The Murphy Builders Site

Many more than me that make this thing tick along Bob.. but thanks!

710E... so you're building an Elite.. it's supposed to come with FUS-452's
vs 70's for the lower front cage to firewall wraps. Not sure what their
intent is on the other pair, but I like a heavier set up on the back deck
between cabin and tail cone for hard tailwheel landings. The .020 Fus-10's
don't hold up there.

Do not know the difference between a 01A and 01. Hopefully it's just a
production modification... and not that one is for taildragger and the A's
are for tri-gear !

Wayne

----- Original Message -----
From: "Bob Bjorn"<bjornretd@xplornet.com>
To:<rebel-builders@dcsol.com>
Sent: Monday, January 16, 2012 6:12 PM
Subject: [rebel-builders] Fuselage Corner Wraps

Hi All, I'm still drilling holes and filling them up with rivets on
Kit 710E

I started digging through my ' parts pile' looking for FUS-10 and FUS-70
and instead i find 4 of FUS-452. Are

these upgrades to go along with the float fittings that I have installed ?

Also I have Main Gear Legs SG-01A. I note in the book it calls for
SG-01 legs. Is there any big problem with

using the -01A legs on a tail drager or are they too short ?

Confused or What, Bob

PS enjoy reading the site, Thanks Wayne for being the ' go to' guy,
Bob