The Murphy Builders Site

Larry,

You should be able to hook up the sending unit to the output side of the oil
pump (above the fuel pump, on the back, right-hand side of the engine,
basically behind the carb). I can dig around a look for pictures of mine or
take some later this week for you.

Ted

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Larry
Sent: Monday, January 09, 2012 1:23 PM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Oil Pressure sending unit on M14-P


Hello, I am hooking up the instruments on my M14-P, I have the Western
fitting kit from Jim Kimball, I can't figure out where to tap into the oil
pressure system to hook up the sending unit. Please advise.

Thanks

Larry Luckinbill

S R 117 Moose




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login username "rebel"
password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------