The Murphy Builders Site

For those who have installed the Fife elevator tips.

I am following the instructions for tip install found in the manual, but due
to the fact that the Fife tips are one piece I am struggling a bit with one
section. The plans call for a L shaped bracket to tie the tip ST31 structure
to the elevator end rib. This is a lot easier with the factory tips as you
can work with the top half off. I am finding it difficult to get rivets into
the L bracket as it is impossible to get a rivet gun into the space.
Hopefully those that have gone before know what I am talking about.


Also, I started to get duplicate copies of all the messages again... anyone
know a quick fix.


Roland
R56





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------