The Murphy Builders Site

Hello,

I am currently installing the seat rails in my rebel.
According to the manual there have to be seat stops (SA-35) with a size
of 3/4" at the front (to be fixed with AN3 bolts).
If I fabricate my seat stops with the recommended size in 3/4 " the
first bolt hole in the rails will be useless, since the bolts can no
more reach it.

So I see two alternatives:
1 - fabricating the stops with a length of 1/2", so that the bolts when
putting the seat in front can just fit in or
2- leaving the first bolt hole useless

I would prefer option 1 but I fear the seat stop will be to small and
may break.

My question is, how did you solve this? Did somebody encounter the same
issues?



Thomas
433R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------