Oh I definitely know his name.. just not sure if he's back to 100% health
wise or wants to take any work on right now. He reads the list...so I've
been leaving it to him to respond.
He's the only one I know of with a jig for the Dynafocal, other than the
factory (and myself).... and they had theirs first so why I've told people
so far to use them as I don't want to step on any toes.
Nobody has a jig for the conical mount, but myself at this point.. TTBOMK...
as the factory stated in the past that they lost theirs.
Wayne
----- Original Message -----
From: "Duane Cromwell" <
dcromwell@healthcareteamtraining.com>
To: <
rebel-builders@dcsol.com>
Sent: Sunday, January 08, 2012 9:26 AM
Subject: RE: [rebel-builders] Back to Work - engine mount
[quote]Wayne,
Do you happen to remember that gentleman's name? Or do you know if there
is an engineering drawing available for the mount?
$950 doesn't seem like a bad price, if I can get the factory to respond.
Thanks,
Duane Cromwell
-----Original Message-----
From:
mike.davis@dcsol.com [mailto:
mike.davis@dcsol.com] On Behalf Of
Wayne G. O'Shea
Sent: Wednesday, January 04, 2012 4:50 PM
To:
rebel-builders@dcsol.com
Subject: Re: [rebel-builders] Back to Work - engine mount
Dynafocal is still available thru the factory.. lastest price, last month,
was $950 for the mount. You still have to buy the four x 94150-40 lord
mounts on top of that from Aircraft Spruce or similar.
There is also a gentleman on the email list that was building them as
well... but he's been quiet for sometime and not sure if he's still up to
the task.
Wayne
----- Original Message -----
From: "Duane Cromwell" <
dcromwell@healthcareteamtraining.com>
To: <
rebel-builders@dcsol.com>
Sent: Wednesday, January 04, 2012 1:32 PM
Subject: RE: [rebel-builders] Back to Work - engine mount
[quote]It's dynafocal.
-----Original Message-----
From:
mike.davis@dcsol.com [mailto:
mike.davis@dcsol.com] On Behalf Of
Wayne G. O'Shea
Sent: Wednesday, January 04, 2012 12:35 PM
To:
rebel-builders@dcsol.com
Subject: Re: [rebel-builders] Back to Work - engine mount
O-235 and O-320 both use the same mount. Only question is whether your
engine is a conical or dynafocal mounting.
----- Original Message -----
From: <
d_.cromwell@dcsol.com>
To: <
rebel-builders@dcsol.com>
Sent: Wednesday, January 04, 2012 12:13 PM
Subject: [rebel-builders] Back to Work
[quote]Hello,
I have recently restarted working on my Rebel and would like to get
re-acquainted with the group. I have kit #266. I started it 18 years
ago
(!). Like many people, life intervened the way it always does, and I
put
the Rebel aside about 10 years ago. I have quite a bit of work
done