Fitting H-stab to Elite Fuselage
Posted: Sun Feb 19, 2012 11:36 pm
I am getting ready to fit the horizontal stabilizer to the fuselage
of Elite 709. The instructions call for removing the AN3 attachment
bolts and drilling to 1/4 inch, one at a time. Then, using the same
procedure to drill the holes out to 5/16 inch. I have found that the
body of a 3/8 drill motor is too big to fit in the space such that
the drill is perpendicular to the brackets. The 1/4-inch pneumatic
drill will fit in the space, but it won't take a 5/16 drill bit or
reamer. Any suggestions on how to drill the holes?
Lynn Cole
Murphy Elite #709
LynnCole@foxvalley.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
of Elite 709. The instructions call for removing the AN3 attachment
bolts and drilling to 1/4 inch, one at a time. Then, using the same
procedure to drill the holes out to 5/16 inch. I have found that the
body of a 3/8 drill motor is too big to fit in the space such that
the drill is perpendicular to the brackets. The 1/4-inch pneumatic
drill will fit in the space, but it won't take a 5/16 drill bit or
reamer. Any suggestions on how to drill the holes?
Lynn Cole
Murphy Elite #709
LynnCole@foxvalley.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------