[rebel-builders] Polygone - Proseal Polysulfide eater! Product Review
Posted: Sun Feb 19, 2012 11:35 pm
Thanks Wayne. Guess I'll stick with acetone for the small areas I need
to clean off.
Ken
On 24/11/2011 7:23 PM, Wayne G. O'Shea wrote:
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
to clean off.
Ken
On 24/11/2011 7:23 PM, Wayne G. O'Shea wrote:
Well Ken... it didn't emulsify it like it did to the Proseal but you can see
in the second picture, if you look close, it ever so slightly wrinkled the
sealant. After letting it sit for about 3 hours (aggitating every 30
minutes) it was then fairly easy to scrape away with a plastic scraper. I
think this and a wipe with Acetone will clean it up pretty good and with
much less fumes than just using an acetone soaked rag. Acetone easily
disolves Sikaflex I find, but takes a lot of it to do so.
This Sikaflex was 14 years old and on well prepped material. I orginally
built the floats that this bulkhead was from in 1997.
http://www.irishfield.on.ca/gallery/pgsikaflex1.jpg
http://www.irishfield.on.ca/gallery/pgsikaflex2.jpg
http://www.irishfield.on.ca/gallery/pgsikalfex3.jpg
http://www.irishfield.on.ca/gallery/pgsikaflex4.jpg
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------