The Murphy Builders Site

I am just installing the torque tube running through the cabin. As per the
instructions the tube is in two sections 40 1/4 and 5 3/8. When I
temporarily install everything including the hangar (which is in the right
place according to plans) there is a 1" discrepancy between what is
extending outside of the fuselage. On the pilot's side I have 2" of the
torque tube showing, whereas on the passenger side I have 1" showing. I
realize there will be spacers to take up the gap between the control horns,
but the discrepancy has me a bit concerned. As I have yet to test mount the
wings with the tube installed, I wondered if this is normal.

Just thought I would check with others before I get too far into this.


Roland
R56




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------