Wing attach hole size - Moose
Posted: Sun Feb 19, 2012 8:54 pm
Hello
I am normally a lurker on this site, but have come upon a
problem and seek advice. In fitting the wing to the front
attach point, the manual calls for a 1/2" reamed hole, the
modification manual calls for a 1/2" hole and a bushing part
number W-712. Does anyone have final size dimensions and
materials spec for this bushing as there weren't any
bushings in the materials that I received. Holes were
previously drilled to 3/4" which makes sense for a bushing
and a 1/2" bolt, but of course there is ever present lack of
direction in the manuals.
Thanks & regards,
David Sproule
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I am normally a lurker on this site, but have come upon a
problem and seek advice. In fitting the wing to the front
attach point, the manual calls for a 1/2" reamed hole, the
modification manual calls for a 1/2" hole and a bushing part
number W-712. Does anyone have final size dimensions and
materials spec for this bushing as there weren't any
bushings in the materials that I received. Holes were
previously drilled to 3/4" which makes sense for a bushing
and a 1/2" bolt, but of course there is ever present lack of
direction in the manuals.
Thanks & regards,
David Sproule
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------