[rebel-builders] Dynon autopilot servos in a SR/Moose
Posted: Sun Feb 19, 2012 8:43 pm
Tim for my future plan to install an elevator servo I chose under the floor
of the baggage are just aft of the push pull bell crank. I plan on the
cable sprocket system instead of the push pull rod method. I plan to clamp
on to the cables going aft. For me it appears to a clean sanitary method of
routing things. I felt that it was getting a bit too busy up front near the
elevator torque tube.
I think others have posted in the web archives some of their photos.
Dick Wampach SR-108 N331RW
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Tim
Saxton
Sent: Saturday, April 09, 2011 10:49 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Dynon autopilot servos in a SR/Moose
Has anyone installed the Dynon servos in a SR/Moose? I'm interested in which
version of the servos to use and the best location to mount the servos.
Tim
SR060
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login username "rebel"
password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
of the baggage are just aft of the push pull bell crank. I plan on the
cable sprocket system instead of the push pull rod method. I plan to clamp
on to the cables going aft. For me it appears to a clean sanitary method of
routing things. I felt that it was getting a bit too busy up front near the
elevator torque tube.
I think others have posted in the web archives some of their photos.
Dick Wampach SR-108 N331RW
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Tim
Saxton
Sent: Saturday, April 09, 2011 10:49 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Dynon autopilot servos in a SR/Moose
Has anyone installed the Dynon servos in a SR/Moose? I'm interested in which
version of the servos to use and the best location to mount the servos.
Tim
SR060
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login username "rebel"
password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------