[rebel-builders] Dynon autopilot servos in a SR/Moose

[Dick Wampach]

Tim for my future plan to install an elevator servo I chose under the floor
of the baggage are just aft of the push pull bell crank. I plan on the
cable sprocket system instead of the push pull rod method. I plan to clamp
on to the cables going aft. For me it appears to a clean sanitary method of
routing things. I felt that it was getting a bit too busy up front near the
elevator torque tube.

I think others have posted in the web archives some of their photos.

Dick Wampach SR-108 N331RW




-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Tim
Saxton
Sent: Saturday, April 09, 2011 10:49 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Dynon autopilot servos in a SR/Moose


Has anyone installed the Dynon servos in a SR/Moose? I'm interested in which
version of the servos to use and the best location to mount the servos.

Tim
SR060



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login username "rebel"
password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------