Page 1 of 1

[rebel-builders] Question of Rebel Datum location/ Cof G range

Posted: Sun Feb 19, 2012 8:35 pm
by Wayne G. O'Shea
That's interesting Ron.. considering the cabin bottom below the door sill is
to be level for weighing.. and the door post is perpendicular to the cabin
bottom.. and the axle should be on the center line of the door post.. and
the door post is behind (aft of) the wings leading edge.

Wayne

----- Original Message -----
From: "Ron Shannon" <rshannon@cruzcom.com>
To: <rebel-builders@dcsol.com>
Sent: Saturday, February 12, 2011 9:27 PM
Subject: Re: [rebel-builders] Question of Rebel Datum location/ Cof G range

On 254R, with spring gear and 8.00x6.00 Carlisle turf tires, the center of
the axle was 0.5" forward of a plumb bob dropped from the leading edge.

Ron
N254MR


On Sat, Feb 12, 2011 at 4:03 PM, Wayne G. O'Shea
<oifa@irishfield.on.ca>wrote:
Gary.. the axle center line is not ahead of the leading edge! It is
indeed
AFT of the wing leading edge.


-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------