elevator trim spar
Posted: Sun Feb 19, 2012 8:35 pm
Hi everyone,
Manual says we are supposed to add 'clips' to connect the trim ribs to the
trim spar. Do they mean all 4 of them, or just the outside ones? This
procedure is a bit of a pain for me, as this part was partially completed by
the previous builder and the spar, skins, and ribs have already been drilled.
Not a lot of room in there.....trying to fit (hold) a 'clip' under a folded skin and
3/4" spar, and then drill through the clip and the rib! Argh!
Looking for a bright idea....or some sympathy! :)
Rob
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Manual says we are supposed to add 'clips' to connect the trim ribs to the
trim spar. Do they mean all 4 of them, or just the outside ones? This
procedure is a bit of a pain for me, as this part was partially completed by
the previous builder and the spar, skins, and ribs have already been drilled.
Not a lot of room in there.....trying to fit (hold) a 'clip' under a folded skin and
3/4" spar, and then drill through the clip and the rib! Argh!
Looking for a bright idea....or some sympathy! :)
Rob
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------