[rebel-builders] Preventing Moose/SR stinger side-to-side movement
Posted: Sun Feb 19, 2012 8:34 pm
Jason: I would not use anything but a good steel bushing machined to size;
rubber, delrin, or anything else which is "soft" will NOT last very long and
you may end up wondering around the landing field. That's my opinion,
regards to you all, a very Happy New Year to all, Eduardo
-----Mensaje original-----
De: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] En nombre de Jason
Beall
Enviado el: jueves, 30 de diciembre de 2010 01:21 p.m.
Para: new list server
Asunto: [rebel-builders] Preventing Moose/SR stinger side-to-side movement
Guys,
Quick question: I have a custom stinger purchased from another builder a few
years back. It's 1 inch in diameter, so there is a slight gap either side of
the stinger up in the tailcone where it mounts.
What have others done to take up this gap? I was thinking either delrin
spacers or some sort of rubber cushion. Thoughts and/or suggestions?
I can see if you don't prevent the side-to-side movement it will eventually
wear the bolt hole on the stinger.
Thanks, -Jason
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
__________ Informaci
rubber, delrin, or anything else which is "soft" will NOT last very long and
you may end up wondering around the landing field. That's my opinion,
regards to you all, a very Happy New Year to all, Eduardo
-----Mensaje original-----
De: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] En nombre de Jason
Beall
Enviado el: jueves, 30 de diciembre de 2010 01:21 p.m.
Para: new list server
Asunto: [rebel-builders] Preventing Moose/SR stinger side-to-side movement
Guys,
Quick question: I have a custom stinger purchased from another builder a few
years back. It's 1 inch in diameter, so there is a slight gap either side of
the stinger up in the tailcone where it mounts.
What have others done to take up this gap? I was thinking either delrin
spacers or some sort of rubber cushion. Thoughts and/or suggestions?
I can see if you don't prevent the side-to-side movement it will eventually
wear the bolt hole on the stinger.
Thanks, -Jason
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
__________ Informaci