The Murphy Builders Site

Use washers to insure a tight fit. You won't wear the bolt hole in the
stinger; you will, however, and almost inevitably regardless of how firm you
washer up the stinger to the FUS-360 (right # ?) mount, end up with
elongated holes in the FUS-360 holes. So while you're at it, install
nutplates/anchor nuts on the back side of each FUS-360 (right/left parts) so
it's easier to replace them later.

Or, create your own custom front stinger mount (as some have done) or buy
Dale Fultz's custom front mount.

Ted

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Jason
Beall
Sent: Thursday, December 30, 2010 10:21 AM
To: new list server
Subject: [rebel-builders] Preventing Moose/SR stinger side-to-side movement

Guys,

Quick question: I have a custom stinger purchased from another builder a few
years back. It's 1 inch in diameter, so there is a slight gap either side of
the stinger up in the tailcone where it mounts.

What have others done to take up this gap? I was thinking either delrin
spacers or some sort of rubber cushion. Thoughts and/or suggestions?

I can see if you don't prevent the side-to-side movement it will eventually
wear the bolt hole on the stinger.

Thanks, -Jason






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------