The Murphy Builders Site

Yep..it's all you can do with it now Dave. Aicraft Spruce and Wagaero's
premade dynafocal rings ship out this way.. with the vents left open. Like
Si pointed out.. when the mount is all welded and done they should be welded
closed before painting/powder coating.

----- Original Message -----
From: "David A. Ricker" <daricker@ns.sympatico.ca>
To: <rebel-builders@dcsol.com>
Sent: Saturday, December 18, 2010 10:46 PM
Subject: Re: [rebel-builders] Dyanfocal engine mount "vent" holes

Hi Wayne

I admit that thought had crossed my mind too. I was thinking that that
might be why they were left open although if it was welded closed then
ingress wouldn't be an issue....

Thanks

Dave

On 12/18/2010 10:40 PM, Wayne G. O'Shea wrote:

I'd use them to your advantage Dave.. spray some tube seal in there to
stop
any rust action and a dab of sealer to close them off. Can't weld them
now
that you're powder coated.

----- Original Message -----
From: "David A. Ricker"<daricker@ns.sympatico.ca>
To:<rebel-builders@dcsol.com>
Sent: Saturday, December 18, 2010 5:09 PM
Subject: Re: [rebel-builders] Conical engine mount

Hi Simon

That's about what I figured and I'm surprised that they were left open.
Perhaps that's a comment on process control?

From your experience is closing them a "must do"?

Cheers,

Dave


On 12/18/2010 11:20 AM, Simon Smith wrote:

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------