The Murphy Builders Site

Good morning everyone,

I've been searching through the archives in vain for a particular post (probably
Wayne's) on the use of a 2x4 clamped to the rear spar of the horizontal stabs as
you position the front attach brackets for drilling through the bulkhead and
doubler. When I try to implement this method, I see no alternative but to to
notch the 2x4 to accommodate the vertical fin. Not difficult to do, obviously,
but I just want to check with the group if there was a 'best-practice' for this
step.

Thanks,

Rob



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------