[rebel-builders] 1800 floats-partial bulkhead .032 doubler
Posted: Sun Feb 19, 2012 8:06 pm
Shown in pictures 24 and 78 on our float build CD. Probably a good idea to
do on all the step area bulkheads.
Wayne
----- Original Message -----
From: <pa18150@gmail.com>
To: <rebel-builders@dcsol.com>
Sent: Sunday, November 07, 2010 10:30 PM
Subject: [rebel-builders] 1800 floats-partial bulkhead .032 doubler
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
do on all the step area bulkheads.
Wayne
----- Original Message -----
From: <pa18150@gmail.com>
To: <rebel-builders@dcsol.com>
Sent: Sunday, November 07, 2010 10:30 PM
Subject: [rebel-builders] 1800 floats-partial bulkhead .032 doubler
wayne, I was unable to locate photo of this mod. in "files". could you
give
the size -"radius" of this 1/2 moon & where the photo is in files? would
this
be a good idea to do on bulkheads F & G? thanks, rich
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------