O-320 Exhaust valve guide wear
Posted: Sun Feb 19, 2012 8:06 pm
Not how I like spending my Friday afternoons!
http://www.irishfield.on.ca/gallery/engine1.jpg
http://www.irishfield.on.ca/gallery/engine2.jpg
http://www.irishfield.on.ca/gallery/engine3.jpg
215 hours SMOH... run on nothing but 100LL. #4 was down to 58/80.... all
leakage air blowing (roaring) out the exhaust. Was going to try the rope
trick for a valve seat lap, and I started into that and got the springs
removed..... only to find that the exhaust valve to guide clearnance was
like throwing a wiener down a hallway.
Was told if one was that way..they probably all were, so I put the # 4 back
together to get an indication of how much the valve stem moved with the
spring/keepers installed and sure enough they are all about the same. Off to
the engine shop tomorrow for new guides and possibly valves. Thankfully I
have a couple sets of valves... so I know they won't be needed!
Wayne
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
http://www.irishfield.on.ca/gallery/engine1.jpg
http://www.irishfield.on.ca/gallery/engine2.jpg
http://www.irishfield.on.ca/gallery/engine3.jpg
215 hours SMOH... run on nothing but 100LL. #4 was down to 58/80.... all
leakage air blowing (roaring) out the exhaust. Was going to try the rope
trick for a valve seat lap, and I started into that and got the springs
removed..... only to find that the exhaust valve to guide clearnance was
like throwing a wiener down a hallway.
Was told if one was that way..they probably all were, so I put the # 4 back
together to get an indication of how much the valve stem moved with the
spring/keepers installed and sure enough they are all about the same. Off to
the engine shop tomorrow for new guides and possibly valves. Thankfully I
have a couple sets of valves... so I know they won't be needed!
Wayne
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------