The Murphy Builders Site

Just test with a magnet

On Aug 3, 2010 12:59 PM, "Dick Wampach" <rwampach@att.net> wrote:

Rob, I doubt that any manufacture would make a f/w that was not to
standards for heat resistance.

You could try to test the material with a file, if an edge is accessible in
a non critical location. Alum is soft, SS is much harder, you should be
able to tell the difference with just a few strokes.

Dick





-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of...

schaumr@dcsol.com
Sent: Tuesday, August 03, 2010 9:53 AM
To: rebel-builders@dcsol.com

Subject: [rebel-builders] Firewall material for Reb #786 (manufactured
2003-2004)?


Hi All,

All th...
-----------------------------------------------------------------

List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubs...




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------