Floor Channels and Seat Rails
Posted: Sun Feb 19, 2012 6:30 pm
Just about to install the floor channels that go below the seat rails. I
have upgraded the channels to .032 (St 28) but am concerned that when back
to back, they will not be wide enough to catch the rivets in the seat rail.
Has anyone put spacers in between the channels so that their edges will
align with the edges of the seat rail?
Roland
R56
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
have upgraded the channels to .032 (St 28) but am concerned that when back
to back, they will not be wide enough to catch the rivets in the seat rail.
Has anyone put spacers in between the channels so that their edges will
align with the edges of the seat rail?
Roland
R56
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------