[rebel-builders] SR/Moose Elevator Horn Bell Crank
Posted: Sun Feb 19, 2012 6:23 pm
You mean the factory can't help by supplying the part (or the diagrams)?
Ted
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Reid
Huzzey
Sent: Monday, May 10, 2010 8:23 PM
To: rebel-builders-d@dcsol.com
Subject: [rebel-builders] SR/Moose Elevator Horn Bell Crank
Anyone have two spare elevator horn bell cranks FUS-304 and two bearings
MI-25. I am missing these parts from my kit. The figure in Chapter 9.2 step
45 shows the part but there are no dimensions. the part should be easy to
make if I knew the thickness of the aluminum and the distance between the
end holes. The bearing part should be able to be purchased.
If anyone can help with a part or a scale diagram posted to the archives or
dimensions, from a part not yet installed, it would be most appreciated.
Reid
Yukon 013Y
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Ted
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Reid
Huzzey
Sent: Monday, May 10, 2010 8:23 PM
To: rebel-builders-d@dcsol.com
Subject: [rebel-builders] SR/Moose Elevator Horn Bell Crank
Anyone have two spare elevator horn bell cranks FUS-304 and two bearings
MI-25. I am missing these parts from my kit. The figure in Chapter 9.2 step
45 shows the part but there are no dimensions. the part should be easy to
make if I knew the thickness of the aluminum and the distance between the
end holes. The bearing part should be able to be purchased.
If anyone can help with a part or a scale diagram posted to the archives or
dimensions, from a part not yet installed, it would be most appreciated.
Reid
Yukon 013Y
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------